National Emission Standards for Hazardous Air Pollutants: Leather Finishing Operations Residual Risk and Technology Review (Renewal)
Extension without change of a currently approved collection
No
Regular
02/28/2025
Requested
Previously Approved
36 Months From Approved
02/28/2025
4
4
138
138
0
0
The National Emission Standards for Hazardous Air Pollutants (NESHAP) for Surface Coating of Metal Coil (40 CFR Part 63, Subpart SSSS) were promulgated on June 10, 2002, and most recently amended on February 25, 2020. These regulations apply to existing facilities and new facilities that are major sources of hazardous air pollutants (HAP) at which a coil coating line is operated. A coil coating line is a process in which special equipment is used to apply an organic coating to the surface of metal coils; the affected source at each plant site is the collection of all coil coating lines at the site. The provisions of this Subpart do not apply to coil coating lines that are part of research or laboratory equipment or coil coating lines on which at least 85 percent of the metal coil coated, based on surface area, is less than 0.15 millimeters (0.006 inches) thick, unless the coating line is controlled by a common control device. New facilities include those that commenced construction or reconstruction after the date of proposal. This information is being collected to assure compliance with 40 CFR Part 63, Subpart SSSS.
On behalf of this Federal agency, I certify that the collection of information encompassed by this request complies with 5 CFR 1320.9 and the related provisions of 5 CFR 1320.8(b)(3).
The following is a summary of the topics, regarding the proposed collection of information, that the certification covers:
(i) Why the information is being collected;
(ii) Use of information;
(iii) Burden estimate;
(iv) Nature of response (voluntary, required for a benefit, or mandatory);
(v) Nature and extent of confidentiality; and
(vi) Need to display currently valid OMB control number;
If you are unable to certify compliance with any of these provisions, identify the item by leaving the box unchecked and explain the reason in the Supporting Statement.
1985t11.xlsx
1985ss11.docx
NESHAP for Leather Finishing Operations (40 CFR Part 63, subpart TTTT)