Owners or operators of plastic parts and products surface coating operations subject to 40 CFR Part 63, Subpart PPPP are required to report startup, initial performance test, and retest information. Facilities also report on a regular basis; emission exceedances, changes to equipment, and other data. Additional records and notifications depend on how the owner or operator chooses to comply with the standards. The owner or operator of a plastic parts and products surface coating operation that is subject to these final standards will be required to control hazardous air pollutants (HAP) by either limiting the HAP content of materials used in the coating operations (compliant material option), demonstrating that the source-wide HAP emissions meet the emission limit (emission rate without add-on controls option), or by using an emission capture and control system to demonstrate that the source-wide emissions meet the emission limitation (emission rate with add-on controls option).
Changes in the Estimates: There is an increase of 278,860 hours in the total estimated burden currently identified in the OMB Inventory of Approved ICR Burdens. The increase in burden reflects the need for facilities to be in compliance with the rule requirements prior to the date of this ICR, and a revision in the number of facilities subject to the NESHAP. The increase in Operations and Maintenance cost is due to installation and maintenance of equipment used to verify compliance with the rule requirements.
$1,343,749
No
No
Uncollected
Uncollected
Uncollected
Uncollected
Len Lazarus 202 564-9281
No
On behalf of this Federal agency, I certify that the collection of information encompassed by this request complies with 5 CFR 1320.9 and the related provisions of 5 CFR 1320.8(b)(3).
The following is a summary of the topics, regarding the proposed collection of information, that the certification covers:
(i) Why the information is being collected;
(ii) Use of information;
(iii) Burden estimate;
(iv) Nature of response (voluntary, required for a benefit, or mandatory);
(v) Nature and extent of confidentiality; and
(vi) Need to display currently valid OMB control number;
If you are unable to certify compliance with any of these provisions, identify the item by leaving the box unchecked and explain the reason in the Supporting Statement.
2044ss03_rev.doc
NESHAP for Plastic Parts and Products Surface Coating (40 CFR part 63, subpart PPPP) (Renewal)